[Kovove materialy - Metallic materials]
    Fri - April 12, 2024 - 22:40 No. of hits : 1740511 ISSN 1338-4252 (online) ISSN 0023-432X (printed)
© Institute of Materials and Machine Mechanics, Slovak Academy of Sciences, Bratislava, Slovak Republic

VOLUME 56 (2018), Issue 4

The influence of chill thickness and austempering temperature on dry sliding wear behaviour of a Cu-Ni carbidic austempered ductile iron (CADI)
vol. 56 (2018), no. 4, pp. 213 - 221
DOI: 10.4149/km_2018_4_213

The influence of chill thickness and applied load were studied on wear behaviour of a carbidic austempered ductile iron containing Cu and Ni. Ductile iron with chemical composition Fe-3.6C-2.6Si-0.53Cu-0.51Ni (in wt.%) was cast into standard moulds with copper end chills of different thicknesses. Wear test samples were prepared from the chilled surface of the blocks. Austenitizing heat treatment was carried out at 870 °C followed by austempering at 270, 320, 370 and 410 °C in electrically heated salt bath furnaces for optimum times. A block-on-ring testing machine was used to carry outwear tests in dry sliding condition under applied loads of 100 and 150 N. Scanning electron microscopy was used to examine the worn surface of the samples. The results indicated an improvement in wear resistance of austempered ductile iron by introducing carbides into the matrix compared to that of non-carbidic samples. Best wear performance in carbidic austempered ductile iron was achieved for a matrix containing about 30 vol.% carbides.

Key words
carbidic austempered ductile iron, sliding wear, chill thickness, block-on-ring

[open article.pdf] Full text (1333 KB)

[IMMS SAS]      UMMS SAV - Bratislava (SK) Personal data Protection   ver. 1.8.0      [go to HOME PAGE]
Full title of this journal is bilingual: Kovové materiály - Metallic Materials.
The official abbreviation in accordance with JCR ISI is Kovove Mater.

Article abstracts updated: 2023-10-26 07:45      
Articles in press revised: 2024-04-11 09:16     
Full text pdf uploaded: 2023-11-08 06:53    
Information updated: 2023-04-19 16:14   
Code last revised: 2024-03-06 11:13  

© OldSoft, 2004, …, 2024